1
12.97
09.01
1.4.5 Configuring tools (MMC 100 / MMC 100.2 only)
Explanation
For MMC 100 / MMC 100.2, you also require a
conversion tool to convert the file format from *.bmp
to *.pcx.
This tool is located on the delivery diskette under the
path MMC100/MMC100.2\TOOLS.
This enables you to carry out conversion and
compression to produce a loadable file for
MMC 100 / MMC 100.2.
The PCX files are converted and subsequently
compressed into an archive file by means of the
tools PCX_CON.EXE and ARJ.EXE. These tool are
contained on the diskette.
The files to be converted must all reside on one
path, multiple paths are not supported.
Conversion routine call:
makepcx.bat
All parameters required have already been stored in
this file.
The conversion produces the files *.b00 *.b01 and
*.b02. Prior to compression, copy all these files
(*.b0* as well as the arj.exe tool into a path and start
the following call:
arj a cst.arj *.*
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1.4 Cycle support in program editor (SW 4.3 and higher)
1
General
1-35