Siemens SINUMERIK 840Di sl Function Manual page 133

12/2008
Notice
PLC counters cannot be used as ePS Network Services counters! It is not
possible to correct this configuration (counters). Instead, the configuration must
be deleted in its entirety and re-entered.
Since it is not possible to use the endless counter function of the PLC, when a
smaller new value is read, ePS Network Services calculates this as an offset to
the old value.
Fig. 3-34: Selection: Variable monitor counter
Field
Name
Add
Selection
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance (see also: Sub-section 6.1.3 "Machines"
and general description of triggers):
•
If a label has been set and a start date, which has not yet been reached, has
been configured in the master data, the trigger will not be initiated.
•
If the date has been reached or is in the past, the trigger will be initiated
according to the conditions set for it.
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
Content
Designation for the new trigger
Add the selection of all possible
variable monitor variables for which a
trigger can be initiated.
The variable can be marked for use
once per trigger. Any number of
variables can be selected.
3 Setting up functions
3.4 Fault services
Type
DISPLAY
INPUT
(Max. 40 charac-
ters; any character
permissible)
ACTION
SELECTION
Master data,
3-133