Siemens SINUMERIK 840Di sl Function Manual page 55

12/2008
Prolog for measurement series4 (testType == "CIRCULARITY")
Checking the return parameters
Measurement4
Epilog for measurement series4 (testType == "CIRCULARITY")
...
Epilog for test series (testType == "FRAME")
testType == "FRAME" marks the call to start and end of the test series. The other
parameters with this call are irrelevant. testType == "CIRCULARITY" identifies a
circularity test measurement. "EQUABILITY" stands for the equability test and
"UNIVERSAL" for the universal axis test.
In the calls placed before and after a measurement, the further call parameters of
the program contain the specific information about the measurement in accordance
with the table.
Description of the call parameters
All position values refer to the machine coordinate system (MCS).
ePS_error
ePS_errMsg
doProlog
testType
testType
measSeriesName
intParam1
intParam2
intParam3
intParam4
intParam5
intParam6
realParam1
realParam2
realParam3
realParam4
realParam5
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
Equability test
Return parameters (see below)
TRUE = Call as prolog
FALSE = Call as epilog
FRAME = Prolog/epilog of the test series
(The following parameters are irrelevant.)
EQUABILITY
Name of the measurement series (in UPPER CASE)
Channel axis number
of the traverse axis
Channel axis number
of the measurement
axis
Reserved
Reserved
Reserved
Reserved
Start position
End position
Reserved
Feed
Reserved
2.3 Test series on the machine
Circularity test
CIRCULARITY
Plane selection
(1 = G17, 2 = G18,
3 = G19)
Reserved
Reserved
Reserved
Reserved
Reserved
1st center point
coordinate of the
circle
2nd center point
coordinate of the
circle
Circle diameter
Feed
Reserved
2 Maschine information
Universal axis test
UNIVERSAL
Channel axis number
of the traverse axis
Reserved
Reserved
Reserved
Reserved
Reserved
Start position
Maximum position
Reserved
Reserved
Reserved
2-55