Motorola MVME2400 Series Installation And Use Manual page 33

Inserting or removing modules with power applied may result in damage
!
to module components.
Caution
Dangerous voltages, capable of causing death, are present in this
!
equipment. Use extreme caution when handling, testing, and adjusting.
Warning
3. Carefully remove the MVME2400 from its VMEbus card slot and
Avoid touching areas of integrated circuitry; static discharge can damage
!
these circuits.
Caution
4. Remove the PCI filler plate from the selected PMC slot in the front
5. Slide the edge connector(s) of the PMC module into the front panel
http://www.motorola.com/computer/literature
lay it flat, with connectors P1 and P2 facing you.
panel of the MVME240x. If installing a double-width PMC, remove
the filler plates from both PMC slots.
opening(s) from behind and place the PMC module on top of the
MVME240x. The four connectors on the underside of the PMC
module should then connect smoothly with the corresponding
connectors for a single-width PMC (J11/J12/J13/J14 or
J21/J22/J23/J24, all eight for a double-width PMC) on the
MVME240x.
Hardware Installation
1-13
1