Chapter 5 Ua5000 Narrow-Band Service - Huawei MA5600 Manual

NGN Cases
0 GE-Optic
Port 0 is incorrectly configured as an optical port. Run the command
mode 0 GE-Electrical to modify the mode of port 0 to GE electrical. Test the port again.
The port is still not activated.
4. Consult the switch side. The peer end is a 100M electrical port. In the IPM mode, run
the following command:
huawei(config-if-ipm-0/2)#speed
{ portid<U><0,15> }:0
{ 10<K>|100<K>|1000<K> }:100
Command:
speed 0 100
Port 0 is modified to a 100M electrical port. Test the port again. The port is activated.
Suggestions By default, the upstream port of the IPMD board is a GE optical port. In practice, if a 100M
and summary:
optical port or electrical port is used for upstream communication, the port mode of the IPMD
board must be modified.
Chapter 5
5.1 Retransmission of H.248 Packets Fails in the UA5000R17C02B107 Because the
Interface Attribute Is Incorrect
Title:
Retransmission of H.248 Packets Fails in the UA5000R17C02B107 Because the Interface
Attribute Is Incorrect
ID: SE0000392262
Update Time: 2009-05-27 16:51:14
Views: 2
Author: q92670
Product Family: Integrated Access
Fault Type: Narrow-band Voice Service
Keywords: H.248
Permission 04Common Users Permission
Level:
Phenomenon De
In a UA5000R17C02B107 site, captured packets show that the AG does not receive reply
scription:
messages from the softswitch when packet loss occurs in the network. As a result, the AG does
not retransmit the lost packets.
Alarm Informati
Null
on:
Cause Analysi
1. The transaction reliability parameter of the H.248 stack is set incorrectly.
72
Confidential Information of Huawei. No Spreading without Permission
3 - 1000 full off
UA5000 Narrow-band Service

Chapter 5 UA5000 Narrow-band Service

active offline
Product: UA5000