Siemens SIMATIC Field PG P4 Manual page 77

Option "Boot Options"
The following submenu appears when you select the option "Boot Options" in the
main menu:
F1
ESC
Fig. 5-5
Quick Boot
Mode
SETUP prompt
POST Errors
Floppy check
Summary
screen
'Enabled' means that the feature is active. 'Disabled' means that the feature is
inactive.
SIMATIC Field PG P4 Manual
A5E00180080-04
PhoenixBIOS Setup Utility
Main
Boot Options
QuickBoot Mode: [Enabled]
SETUP prompt: [Enabled]
POST Errors: [Enabled]
[Disabled]
Floppy check:
[Disabled]
Summary screen:
Help Select Item
Exit Select Menu
"Boot Options" Submenu
Some hardware tests are skipped to speed up the boot procedure.
The message PRESS <F2> to enter Setup appears at the bottom of the
screen during the system run-up phase.
The boot process is stopped if an error is detected; you must press F1 to
confirm. Enter "Disabled"to avoid the necessity of acknowledging errors,
for example if no keyboard is connected.
The floppy head is stepped inward and then back to its original position
during the system run-up phase. This test is useful because it reinitiali-
zes the drive.
The most important system parameters are displayed when the system
run-up phase completes.
Configuring the SIMATIC Field PG P4
Item Specific Help
Allows the system to
skip certain tests
while booting. This
will decrease the
time needed to boot
the system.
+ / – Change Values F9
Select
Enter Sub-Menu F10
Setup Defaults
Save and Exit
5-9