6.4
Switching to the Service Desktop during autologon mode
If you have set up autologon mode, the PCU automatically boots with the logged-on default
user account SINUMERIK Operate.
But you can also log on directly as an administrator for the Service Desktop during start-up if
you want to perform maintenance, for example. In this case, you must press a key (key 3)
while the PCU is booting.
Precondition
● SINUMERIK Operate is installed and autologon mode is set up.
● The PCU is switched off.
Procedure
Proceed as follows to log on as an administrator when autologon mode is set up.
1. Switch on the PCU and wait until the "SINUMERIK" welcome screen appears.
2. Press key 3 on the keyboard while the "SINUMERIK" welcome screen is being displayed.
3. Select the "Display Desktop" option.
Result
The Service Desktop opens.
PCU Base Software (IM10)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
See Chapter Setting up SINUMERIK Operate for autologon mode (Page 41).
The counter for starting SINUMERIK Operate is suspended and you can select one of
three options:
Figure 6-3
Welcome screen "SINUMERIK" after key input
6.4 Switching to the Service Desktop during autologon mode
Service and diagnostics
89