Siemens SINUMERIK 840D sl Commissioning Manual page 769

3. An icon can also be displayed on the softkey in addition to the text.
4. The position of the softkey can also be set. The following entry in the [Custom] section
8.3 How to configure the "Custom" operating area
Configuring the softkey for the "Custom" operating area
You need the easyscreen.ini and custom.ini files to configure the operating area. Templates
for both these files are available in the
1. First copy the files to the
2. File easyscreen.ini already contains a definition line for the "Custom" operating area:
3. You create the custom.com project file in the
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 03/2013, 6FC5397-1DP40-3BA1
To do this, the following must be entered in the [Custom] section:
Picture=mypicture.png
The softkey then displays the icon from the file mypicture.png. Graphics and bitmaps are
stored at the following path: /oem/sinumerik/hmi/ico/ico<Resolution>. The directory that
corresponds to the display resolution must be used.
can be used to make this setting:
SoftkeyPosition=12
The default is position 12. This corresponds to the HSK4 on the menu continuation bar of
the operating area's menu. Positions 1 - 8 correspond to HSK1 to HSK8 on the menu bar,
positions 9 - 16 to HSK1 to HSK8 on the menu continuation bar.
there.
;StartFile02 = area := Custom, dialog := SlEsCustomDialog, startfile := custom.com
The ";" at the start of the line represents the comment character. This means the line is
commented out and, as such, not active. To change this, the ";" must be deleted.
The "startfile" attribute in this line is used to define that the entry will refer to the
custom.com project file when the "Custom" operating area is selected.
contains the relevant configuration, which is created in the same way as the aeditor.com
file of the "Program" operating area. The configured start softkeys are then displayed in
the "Custom" operating area.
8.3 How to configure the "Custom" operating area
/siemens/sinumerik/hmi/templates/cfg
/oem/sinumerik/hmi/cfg
/oem/sinumerik/hmi/proj
"Custom" operating area
directory and make your changes from
directory. This
directory.
151