General Machine Data For Safety Integrated - Siemens SINUMERIK 840D sl Commissioning Manual

Safety Integrated
21.1 Displaying machine data and parameters
See also
Copying and confirming Safety Integrated data (Page 435)
Activating/deactivating start-up mode (Page 436)
Displaying the Safety-Integrated settings (Page 437)
21.1.2

General machine data for Safety Integrated

The general machine data is listed in the "Selection of General MD" window and can be
edited, copied and confirmed.
Note
Changes as well as copying and confirming are effective for all axes and the general
machine data.
Screen view
The machine data display is split into two halves:
● In the upper part of the screen view, the machine data that are important for
commissioning are displayed; however, they do not involve Safety Integrated machine
data.
● Safety Integrated machine data are displayed in the lower part of the screen view.
Changing the screen view
432
1. Press the "MD selection" to change into the full screen view.
The selection of general machine data is displayed over the complete
screen.
2. Press the "SI-MD" softkey.
The general safety integrated machine data are displayed over the full
screen.
3. Press the "SI + MD selection" softkey.
You return to the common view split in two of the general machine data
and the Safety Integrated machine data.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)