Siemens SINUMERIK 840D sl Commissioning Manual page 118

Simulation and simultaneous recording
9.2 Configuring the simulation
Meaning of the axes
MD52206 $MCS_AXIS_USAGE[n]
= 0
= 1
= 2
= 3
= 4
= 5
= 6
= 7
= 8
= 9
Enter the direction of rotation for the rotary axes that are not configured in a toolholder or a
5-axis transformation via the following channel-specific machine data.
MD52207 $MCS_AXIS_USAGE_ATTRIB[n]
Bit 0
Bit 1
Bit 2
Bit 3
MD52290 $MCS_SIM_DISPLAY_CONFIG
Bit 0
Bit 1
Bit 2
Bit 3
112
No special meaning
Tool spindle (driven tool)
Auxiliary spindle (driven tool)
Main spindle (turning)
C axis of the main spindle (turning)
Counterspindle (turning)
C axis of the counterspindle (turning)
Linear axis of the counterspindle (turning)
Tailstock (turning)
Back rest (turning)
Rotation around 1st geometry axis (for rotary axes)
Rotation around 2nd geometry axis (for rotary axes)
Rotation around 3rd geometry axis (for rotary axes)
Reversal of direction of rotation (for rotary axes)
Upper left-hand corner
Upper right-hand corner
Lower left-hand corner
Lower right-hand corner
Meaning of the axes in the channel
[n] channel axis number
Attributes of the axes
[n] channel axis number
Position of the status display of the channel in the
simulation.
This MD only acts on OP019.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)