Siemens SINUMERIK 840D sl Commissioning Manual page 132

Tool management
12.1 Machine data for tool management
MD19320 $ON_TECHNO_FUNCTION_MASK
=2000000H
Bit 25
Setting with magazine management
Make the following settings if you are commissioning the tool management with NC
magazine management:
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK
= 03H
Bit 0
Bit 1
MD20310 $MC_TOOL_MANAGEMENT_MASK
= 03H
Bit 0
Bit 1
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER
= 1FH
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
MD28450 $MC_MM_TOOL_DATA_CHG_BUFF_SIZE
= 100
MD19320 $ON_TECHNO_FUNCTION_MASK
= 10H
Bit 4
126
Enables the tool monitoring function without magazine management.
Provide tool management data.
Provide monitoring data.
Magazine management active.
Monitoring functions of tool management active.
Tool status change.
Tool remaining unit quantity change.
Tool data change service.
Magazine data in the change service.
ISO data in the change service.
Number of entries in the buffer for the OPI change service for tool data. Dynamic memory
is used. This buffer is only created if either bit 2 or bit 3 is set in
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER.
Enables the tool monitoring function with magazine management.
Memory for the tool management is
reserved step-by-step (SRAM).
Activating the tool management
functions.
Marking the changed tool data for HMI.
Buffer for changing tool data (DRAM).
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)