Inserting A User-Specific Logo - Siemens SINUMERIK 840D sl Commissioning Manual

Customizing the "Machine" operating area

8.2 Inserting a user-specific logo

8.2 Inserting a user-specific logo
OEM-specific logo
The Siemens logo is visible in the header of the "Machine" operating area.
You can replace the Siemens logo with your own logo.
Procedure:
1. Name your own logo "
Note
The file name must not contain any lower case letters.
2. Save your own logo depending on the bitmap size, in one of the directories:
/oem/sinumerik/hmi/ico or /user/sinumerik/hmi/ico
Directory
/Ico640
/Ico800
/Ico1024
8.3 Configuring the display of the G-code groups
The "G-functions" pane is visible in the "Machine" operating area.
Up to a maximum of 16 G-code groups are displayed in this pane. Configure the
"slmagcodeconfig.ini" file accordingly to determine which G-code groups should be
displayed, and where.
Configuring G-code groups
Section
Selected G groups
Selected G groups ISO
mode
Enter the G-code group and position as follows:
SelectedGGroupN = M
N
M
92
logo.png
Bitmap size
122 x 19
160 x 24
199 x 30
Meaning
This area is intended for operation of the controller in Siemens mode.
This area is intended for operation of the controller in ISO mode.
Position where G-code group M will be displayed.
If you want to leave a position empty, omit the number (M), e.g. "
The number of the G-code group to be displayed at position N
".
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
"
SelectedGGroup1 =
SINUMERIK Operate (IM9)