Siemens SINUMERIK 840D sl Commissioning Manual page 545

MD20310 $MC_TOOL_MANAGEMENT_MASK
= 4002H
Bit 1 = 1
Bit 14 = 1
MD28082 $MC_SYSTEM_FRAME_MASK
Bit 0 = 0
Bit 0 = 1
The following channel-specific machine data is only effective if the system frame actual value
setting and scratching is set up using the above mentioned machine data
MD28082 $MC_SYSTEM_FRAME_MASK, bit 0 = 0.
MD24006 $MC_CHSFRAME_RESET_MASK
Bit 0 = 1
MD24007 $MC_CHSFRAME_RESET_CLEAR_MASK
Bit 0 = 0
Note
If you create the conditions described in this section and you have set and checked the
machine setting data, then in JOG mode, you can measure a workpiece using a workpiece
probe at a milling machine!
In JOG mode, you can measure a tool using a tool probe at a milling machine or lathe!
A description is provided in the following chapters as to which settings you can make in order
to adapt measuring to the specific requirements of your particular machine.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Minimum value
Tool manager and monitoring functions active
Automatic tool change for RESET and Start.
Do not setup system frames for actual value setting and scratching.
Setup system frames for actual value setting and scratching.
Reset response of the system frames or actual value setting.
Clear response of the system frames on reset.
22.8 Measuring cycles and functions
Activates tool manager functions
System frames (SRAM).
Active system frames after reset.
Clear system frames on reset.
Configuring cycles
539