Siemens SINUMERIK 840D sl Commissioning Manual page 193

Example 2
A new parameter is configured in the following example from Section Configure the list
parameters (Page 153):
<PARAMETERCONFIGURATION>
</PARAMETERCONFIGURATION>
The two texts under HeadLine and ToolTip should be output depending on the language. To
do this, the two text identifiers must be included in the sltmlistdialog_xxx.ts file:
<?xml version="1.0" encoding="UTF-8"?>
<!DOCTYPE TS><TS>
<!--
<!--
<!--
<context>
<!--
<!--
<!--
<!--
<!--
<!--
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
<EdgeUser_1_Bit0>
<Base value="EdgeUser_1" type="QString" />
<ItemType value="CheckBox" type="QString" />
<DisplayMode value="AnyMode" type="QString" />
<BitMask value="1" type="int" />
<Width value="17" type="int" />
<HeadLine value="TM_HL_EDGE_USER_1_Bit0" type="QString" />
<ToolTip value="TM_TT_EDGE_USER_1_Bit0" type="QString" />
</EdgeUser_1_Bit0>
************************************************************ -->
Definition of OEM texts
************************************************************ -->
<name>SlTmListForm</name>
************************************************************ -->
enter your text behind this comment -->
************************************************************ -->
************************************************************ -->
Translate the text for the headline -->
************************************************************ -->
<message>
<source>TM_HL_EDGE_USER_1_Bit0</source>
<translation>heavy %n tool</translation>
<chars>10</chars>
<lines>2</lines>
</message>
Tool management
12.3 Creating OEM texts
187