Block Search - Siemens SINUMERIK 840D sl Commissioning Manual

8.7

Block search

8.7.1 Activating block search mode
Block search mode settings
The following machine data can be used to set the possible variants for the block search with
G-code programming:
MD51028 $MNS_BLOCK_SEARCH_MODE_MASK
Bit 0 = 1
Bit 1 = 1
Bit 4 = 1
Bit 5 = 1
The following machine data can be used to set the possible variants for the block search in a
JobShop program (ShopMill, ShopTurn):
MD51024 $MNS_BLOCK_SEARCH_MODE_MASK_JS
Bit 0 = 1
Bit 1 = 1
Bit 3 = 1
Bit 5 = 1
Note
The "Block search mode" softkey is only displayed, if, in the machine data MD51024 and
MD51028, more than one version for the block search has been defined; for example "Block
search with calculation without approach" and "Block search with calculation with approach".
When so doing, take into account that the search versions set active in the "Block search
mode" window are also referred to the program.
8.7.2 Accelerated block search for execution from external
The accelerated block search function allows you to run the part program forward until you
reach the block you require.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Block search with calculation, without approach
Block search with calculation, with approach
Block search without calculation
Block search with test run
Block search with calculation, without approach (default setting)
Block search with calculation, with approach
Skip EXTCALL programs
Block search with test run
Customizing the "Machine" operating area
Bit mask for the available search modes
Bit mask for the available search modes
(ShopMill, ShopTurn, single-channel)
8.7 Block search
99