Control Response To Power On, Mode Change, Reset, Block Search, Repos; List Of Machine Data Affected - Siemens SINUMERIK Series Function Manual

6.8.3

Control response to power ON, mode change, RESET, block search, REPOS

With the aid of the following machine data it is possible to select a transformation
automatically in response to
MD20110 $MC_RESET_MODE_MASK
MD20112 $MC_START_MODE_MASK
and
MD20140 $MC_TRAFO_RESET_VALUE
This may result in the generation of an alarm, for example, at the end or start of a program, if
the machine data of an active transformation has been altered.
To avoid this problem when re-configuring transformations via an NC program, we therefore
recommend that NC programs are structured as follows:
Program code
N10 TRAFOOF()
N20$MC_TRAFO5_BASE_TOOL_1[0]=0
N30$MC_TRAFO5_BASE_TOOL_1[0]=3
N40$MC_TRAFO5_BASE_TOOL_1[0]=200
N130 NEWCONF
N140 M30
6.8.4

List of machine data affected

Machine data which can be made
All transformations
Machine data which are relevant for all transformations:
● MD24100 $MC_TRAFO_TYPE_1 to MD24480 $MC_TRAFO_TYPE_10
● MD24110 $MC_TRAFO_AXES_IN_1 to MD24482 $MC_TRAFO_AXES_IN_10
● MD24120 $MC_TRAFO_GEOAX_ASSIGN_TAB_1 to
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
6.8 Activating transformation machine data via part program/softkey
MD24484 $MC_TRAFO_GEOAX_ASSIGN_TAB_10
(i.e. at end of program as well) and/or on program start:
RESET
Comment
; Select a possibly still active
; Enter machine data
;
;
compatible are listed below.
NEWCONFIG
M1: Kinematic transformation
transformation
Newly entered machine data
Transfer
415