Transferring An Axis Or Spindle Into The Part Program (Get, Getd) - Siemens SINUMERIK Series Function Manual

K5: Mode groups, channels, axis interchange
5.4 Axis/spindle replacement
5.4.6

Transferring an axis or spindle into the part program (GET, GETD)

Options
The release time and the behavior of an axis or spindle replacement is influenced in the part
program as follows:
● Programming with the GET command in the same channel.
● Directly from another channel through programming with GETD.
References:
Programming Manual Job Preparation; Flexible NC Programming,
Section: Axis replacement, spindle replacement (RELEASE, GET, GETD)
With the GETD command
GET (axis name, axis name, SPI (spindle no.), ...)
The takeover of an axis is delayed if
● the axis is changing the measuring system.
● servo disable is being processed for the axis (transition from control in follow-up/stop and
● the axis/spindle disable is set.
● the axis has not yet been enabled by the other channel with RELEASE.
● interpolation for the axis has not yet been completed (except for a speed-controlled
With GET (axis name, ...) a separate NC block with pre-processing stop is always generated.
Exceptions:
● If the axis is already a channel axis, then no block is generated.
● If the axis is synchronous, (i.e. it has not been swapped to another channel in the
326
vice versa).
spindle).
meantime or received a signal from the PLC) no extra block is generated either.
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions