Siemens SINUMERIK Series Function Manual page 952

Index
with synchronized actions, 667
Oscillating axis, 641
Oscillation active, 901
Oscillation cannot start, 900
Oscillation movement active, 901
Oscillation reversal active, 900
OSCTRL,
OSE, 649
OSNSC, 649
OSP, 647
OST, 647
Output cam
-pair, 535
-positions, 543
-range, 535
-signals, 535
Output values, 452
Overlap areas of axis angles
TU address, 402
Overwrite screen form for analog NCK outputs, 841
Overwrite screen form for digital NCK outputs, 838
P
p0680, 449
p0684, 449
p0922, 449
Part program, 430
Passive file system, 756
path
-interpolator, 606
Path default using handwheel, 178
Path segmentation, 573
Permanently configured coupling, 707
Plane separation, 455
PLC axes, 629
PLC axis, 330
axes under exclusive PLC control, 630
permanently assigned PLC axis, 630
start via FC18, 632
PLC controls axis, 900
PLC service display, 450
PLC-controlled axis, 896
Control response to MD30460 bits 6 and 7, 634
Plus
-output cam, 535
Plus cam signals 1-32, 889
Position of tool zero, 374
Position offset
In synchronous spindles, 732
Position switching signals, 535
Lead/delay times, 545
952
Positioning axes, 600
Axis types, 603
Axis-specific signals, 630
Channel-specific signals, 630
Concurrent, 629
Dry run feedrate, 635
Maximum number, 617
Tool offset, 620
Types, 603
Positioning axis dynamic response, 616
Position-time cams, 551
POSP, 655
Power On, 398
Preset actual value memory, 451
for geo axes and special axes ($AC MEAS TYPE =
14), 481
for special axes ($AC MEAS TYPE = 15), 482
Probe actuated, 887
Probe function test, 524
Processing
face-end, 347
PROFIBUS I/O, 54
Program
-coordination, 308
Programming of joint position
STAT address, 401
Programming with groove wall offset, 422
Programming without groove wall offset, 424
PTP/CP switchover
Mode change in JOG, 404
PUNCHACC, 569
R
RangeIndex, 60
RangeOffset, 60
Rapid traverse
Interpolation types, 606
Rapid traverse override, 145
Read offset, 718
Reconfiguration, 757
Redefine WCS on the oblique plane
($AC_MEAS_TYPE = 18), 488
Reference point approach, 182
RELEASE, 325
Release guide axis, 325
Replaceable geometry axes, 374
Replaceable geometry axis, 354
Reset, 399
Response to setpoint changes, 744
Resynchronization, 732
Reversal points, 641
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions