Siemens SINUMERIK Series Function Manual page 811

Access from part program
Parameters can be read and written from the part program.
Example
Read the current width of tool 2 and store in R10
Write value 2000 to the maximum speed of tool 3
$P_ATPG[m] for current tool
This system variable allows the tool-specific grinding data for the current tool to be
accessed.
m:
Example:
Parameter 3 ($TPG3[<T No.>])
$P_ATPG[3]=R10
Note
The monitoring data applies to both the left-hand and the right-hand cutting edge of the
grinding wheel.
The tool-specific grinding data is activated when
surface speed) and
that has been modified, it is necessary to program
The length compensations always specify the distances between the tool carrier reference
point and the tool tip in the Cartesian coordinates (must be noted for inclined grinding
wheel).
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Parameter number (data type: Real)
(select tool monitoring) are programmed. To activate a data item
TMON
W4: Grinding-specific tool offset and tool monitoring
17.1 Tool offset for grinding operations
Programming
R10 = $TC_TPG5 [2]
$TC_TPG6 [3] = 2000
(select constant grinding wheel
GWPSON
or
GWPSON TMON
again.
811