Programming Example For Gwps - Siemens SINUMERIK Series Function Manual

W4: Grinding-specific tool offset and tool monitoring
17.5 Constant grinding wheel peripheral speed (GWPS).
Programming
The spindle speed can be modified through the input of a grinding wheel peripheral speed.
The spindle speed can be modified through:
● programming in the part program/overstoring
● programming the grinding wheel peripheral speed through assignment to address "S" in
● spindle speed control via PLC (FC18).
DB31, ... DBX84.0 (GWPS active)
The following interface signal can be used to determine whether or not the GWPS is active:
DB31, ... DBX84.0 (GWPS active)
17.5.4

Programming example for GWPS

Data of tool T1 (peripheral grinding wheel)
$TC_DP1[1,1] = 403
$TC_DP3[1,1] = 300
$TC_DP4[1,1] = 50
$TC_DP12[1,1] = 0
$TC_DP13[1.1] =0
$TC_DP21[1.1] =300
$TC_DP22[1.1] =400
$TC_TPG1[1] = 1
$TC_TPG8[1] = 0
$TC_TPG9[1] = 3
Data of tool T5 (inclined grinding wheel)
$TC_DP1[5,1] = 401
$TC_DP3[5,1] = 120
$TC_DP4[5,1] = 30
$TC_DP12[5,1] = 0
$TC_DP13[5,1] =0
$TC_DP21[5,1] =100
$TC_DP22[5,1] =150
$TC_TPG1[5] = 2
$TC_TPG8[5] = 45
$TC_TPG9[5] = 3
832
MDA
;Tool type
;Length1
;Length2
;Wear length 1
;Wear length 2
;Base length 1
;Base length 2
;Spindle number
;Angle of inclined wheel
;Parameter no. for radius calculation
;Tool type
;Length1
;Length2
;Wear length 1
;Wear length 2
;Base length 1
;Base length 2
;Spindle number
;Angle of inclined wheel
;Parameter no. for radius calculation
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions