Siemens SINUMERIK Series Function Manual page 862

Z2: NC/PLC interface signals
18.3 Manual and Handwheel Travel (H1)
DB21, ...
DBX12.4,
DBX16.4,
DBX20.4 Traversing key disable for geometry axis (1, 2, 3)
Edge evaluation: No
Signal state 1 A traversing request using the "Plus" and "Minus" traversing keys is ignored for the geometry axis.
If the traversing key disable is activated while traversing, then traversing is canceled.
Signal state 0 The plus and minus traversing keys are enabled.
Application It is thus possible, depending on the operating mode, to disable manual traversing of the geometry
example(s) axis in JOG mode with the traversing keys from the PLC user program.
Corresponding to ... DB21, ... DBX12.6-7 ff (traversing key plus or traversing key minus for geometry axis)
DB21, ...
DBX12.5,
DBX16.5,
DBX20.5 Rapid traverse override for geometry axis (1, 2, 3)
Edge evaluation: No
Signal state 1 Moves the axis due to a traversing request:
•
•
when the interface signal is set, the geometry axis is moved with rapid traverse.
The rapid traverse feedrate is defined in machine data:
MD32010 $MA_JOG_VELO_RAPID (conventional rapid traverse)
The rapid traverse override is effective in JOG mode for:
•
•
The rapid traverse velocity can be influenced using the rapid traverse override switch.
Signal state 0 The geometry axis traverses with the defined JOG velocity:
SD41110 $SN_JOG_SET_VELO (axis velocity with JOG)
or
MD32020 $MA_JOG_VELO (conventional axis velocity).
Signal irrelevant for
•
...
•
Corresponding to ... DB21, ... DBX12.6-7 ff (traversing key plus and traversing key minus for geometry axis)
Further references Function Manual, Basic Function; Feedrates (V1)
862
Signal(s) updated: Cyclically
Signal(s) updated: Cyclically
DB21, ... DBX12.7 == 1 (traversing key plus)
DB21, ... DBX12.6 == 1 (traversing key minus)
Continuous travel
Incremental travel (INC1, INC10, ...)
Operating modes AUTOMATIC and MDI
Reference point approach (JOG mode)
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions