Traang Oblique Angle Transformation (Option) - Siemens SINUMERIK Series Function Manual

M1: Kinematic transformation

6.4 TRAANG oblique angle transformation (option)

Interrupt part program
● Mode change from AUTOMATIC to JOG
● START after RESET
6.4 TRAANG oblique angle transformation (option)
The angle transformation or "inclined axis" transformation permits the programming in the
perpendicular workpiece coordinate system (WCS) on machines with inclined machine axes.
A typical axis orientation for grinding machines:
X
Z
MZ
MU
α
378
If a part program machining is interrupted for active transformation and traversed
manually in the JOG operating mode, ensure for continuation of the part program in the
AUTOMATIC operating mode that the transformation is already active in the restart block
from the current position to the interruption location.
WARNING
Risk of collision
No monitoring for collisions takes place.
The operator is responsible for ensuring that the tool can be re-positioned without any
difficulties.
If a part program machining is interrupted with
at part program begin all axes travel with a linear block (G0 or G1) to a defined position,
and the remaining part program is traversed reproducably. A tool which was active on
may no longer be taken into account by the control (settable via machine data).
RESET
Geometry axis
Geometry axis
Machine axis
Machine axis
Angle of inclined axis
and restarted with
RESET
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
, ensure that
START
Extended Functions