Siemens SINUMERIK Series Function Manual page 882

Z2: NC/PLC interface signals
18.3 Manual and Handwheel Travel (H1)
DB31, ...
DBB64
Bit 5, 4 Plus and minus traversing request
Edge evaluation: no
Signal state 1 or A traverse movement of the axis is to be executed in one or the other direction. Depending on the
edge change 0 → 1 mode selected, the command is triggered in different ways:
•
•
•
Signal state 0 or A traversing command in the relevant axis direction has not been given or a traverse movement
edge change 1 → 0 has been completed.
•
•
•
Application To release clamping of axes with clamping (e.g. on a rotary table).
example(s)
Note:
If the clamping is not released until the traversing command is given, these axes cannot be
operated under continuous path control!
Corresponding to ... DB31, ... DBX4.7 and/or DBX4.6 (traversing key plus and traversing key minus)
DB31, ... DBX64.7 and/or DBX64.6 (Traversing command plus and minus)
DB31, ...
DBB64
Bit 7, 6 Plus and minus traversing command
Edge evaluation: no
The signal has the effect as described, if Bit 0 in the machine data:
MD17900 $MN_VDI_FUNCTION_MASK (setting for VDI signals)
is set to 0.
If bit 0 in the MD is set to 1, then the signal changes to 1 only if the axis is actually moving.
The interface signal
DB31, ... DBX64 Bit 5, 4 (traversing request plus/minus)
, which is always output, has the same effect as signal traversing command plus/minus when MD17900 bit 0 = 0.
882
Signal(s) updated: Cyclic
JOG mode:
With the plus or minus traverse key.
REF mode:
With the traverse key that takes the axis to the reference point.
AUT/MDA mode:
A program block containing a coordinate value for the axis in question is executed.
JOG mode:
The traversing command is reset depending on the current setting "jog or continuous mode"
(see interface signal DB31, ... DBX4.7 or DBX4.6).
While traversing with the handwheel.
REF mode:
When the reference point is reached.
AUT/MDA mode:
The program block has been executed (and the next block does not contain any coordinate
values for the axis in question).
Cancel by "RESET", etc.
DB21, ... DBX25.7 (axes disable) is active.
Signal(s) updated: Cyclic
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions