Siemens SINUMERIK Series Function Manual page 723

Delete couplings
Language command "
COUPDEL (FS, LS)
Note
COUPDEL
16797 is therefore meaningless.
The following spindle adopts the last speed. This corresponds to the behavior associated
with
Activate original coupling parameters
Language command "
parameters.
COUPRES (FS, LS)
The parameters modified using
deleted.
Language command "
data (configured coupling) and activates the default settings (user-defined coupling).
Programmable block change
It is possible to mark a point in the NC program using the "
system waits at this point for fulfillment of the synchronism conditions for the specified FS
and delays changes to new blocks until the specified state of synchronism is reached (see
"Figure 13-3 Synchronism monitoring with COUPON and synchronism test mark WAITC with
synchronization on a turning leading spindle (Page 719)").
WAITC (FS)
Advantage: The time between activating the synchronous coupling and reaching
synchronism can be used in a meaningful way, technologically speaking.
Note
Basically, it is always possible to write WAITC. If the spindle indicated is not active as FS,
the command for this spindle is without effect.
If no synchronism condition is indicated, the check is always performed for the synchronism
condition programmed/configured on the respective coupling, at least for the setpoint
synchronism.
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
COUPDEL
impacts on an active coupling, deactivates it and deletes the coupling data. Alarm
(FS, LS).
COUPOF
COUPRES
COUPRES
" is used to delete user-defined couplings.
" can be used to re-activate the configured coupling
(including the transformation ratio) are subsequently
COUPDEF
" activates the parameters stored in the machine and setting
S3: Synchronous spindle
13.2 Programming
" language command. The
WAITC
723