Parameters For Block Search In The Search Pointer; Block Search Mode - Siemens SINUMERIK 840D sl Operating Manual

6.7.5

Parameters for block search in the search pointer

Parameter
Number of program level
Program:
Ext:
P:
Line:
Type
Search target
6.7.6

Block search mode

Set the desired search variant in the "Search Mode" window.
The set mode is retained when the the controller is shut down. When you activate the "Search"
function after restarting the controller, the current search mode is displayed in the title row.
Grinding
Operating Manual, 05/2017, A5E40869190
3. If the "Higher level" and "Lower level" softkeys are available, use these
to change the program level.
4. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into account.
The search screen closes.
The current block will be displayed in the "Program" window as soon as
the target is found.
5. Press the <CYCLE START> key twice.
The execution will continue from the interruption point.
Meaning
The name of the main program is automatically entered
File extension
Number of subprogram repetitions
If a subprogram is performed several times, you can enter the number of the
pass here at which processing is to be continued
Is automatically filled for an interruption point
" " search target is ignored on this level
N no. Block number
Label Jump label
Text string
Subprg. Subprogram call
Line Line number
Point in the program at which machining is to start
Machining the workpiece
6.7 Starting execution at a specific point
129