Simulating machining
7.2 Simulation before machining of the workpiece
● Changes to the toolcarrier or transformation data only become effective after Power On.
● Transformation change and swivel data record change are supported. However, a real
kinematic change is not supported, where a swivel head is physically changed.
7.2
Simulation before machining of the workpiece
7.2.1
Simulation before machining of the workpiece
Before machining the workpiece on the machine, you have the option of performing a quick
run-through in order to graphically display how the program will be executed. This provides a
simple way of checking the result of the programming.
Feedrate override
The rotary switch (override) on the control panel only influences the functions of the "Machine"
operating area.
Press the "Program control" softkey to change the simulation feedrate. You can select the
simulation feedrate in the range 0 to 120%.
7.2.2
Start simulation
Procedure
Table 7-1
- OR -
180
1.
Select the "Program Manager" operating area.
2.
Select the storage location and position the cursor on the program to be
simulated.
3.
Press the <INPUT> or <Cursor right> key.
- OR -
Double-click the program.
The selected program is opened in the "Program" operating area.
4.
Press the "Simulation" softkey.
Operating Manual, 05/2017, A5E40869190
Grinding