Siemens SINUMERIK 840D sl Operating Manual page 27

Grinding
Operating Manual, 05/2017, A5E40869190
<END> + <SHIFT>
Moves the cursor to the last entry.
Selects a contiguous selection from the cursor position up to the end
of a program block.
<END> + <CTRL>
Moves the cursor to the last entry in the last line of the current column
or to the end of a program.
<END> + <CTRL> + <SHIFT>
Moves the cursor to the last entry in the last line of the current column
or to the end of a program.
Selects a contiguous selection from the cursor position up to the end
of a program block.
<BACKSPACE>
● Editing box
Deletes a character selected to the left of the cursor.
● Navigation
Deletes all of the selected characters to the left of the cursor.
<BACKSPACE> + <CTRL>
● Editing window
Deletes a word selected to the left of the cursor.
● Navigation
Deletes all of the selected characters to the left of the cursor.
<TAB>
● Indents the cursor by one character in the program editor.
● Moves the cursor to the next entry to the right in the program
manager.
<TAB> + <SHIFT>
● Indents the cursor by one character in the program editor.
● Moves the cursor to the next entry to the left in the program
manager.
<TAB> + <CTRL>
● Indents the cursor by one character in the program editor.
● Moves the cursor to the next entry to the right in the program
manager.
<TAB> + <SHIFT> + <CTRL>
● Indents the cursor by one character in the program editor.
● Moves the cursor to the next entry to the left in the program
manager.
<CTRL> + <A>
Selects all entries (only in the program editor and program manager)
in the current window.
<CTRL> + <C>
Copies the selected content.
Introduction
2.2 Operator panel fronts
27