Tool Details; Displaying Tool Details - Siemens SINUMERIK 840D sl Operating Manual

Procedure
...
13.12

Tool details

13.12.1

Displaying tool details

The following parameters of the selected tool can be displayed using softkeys in the "Tool
Details" window.
● Tool data (Page 290)
● Grinding data (Page 291)
● Cutting edge data (Page 292)
● Monitoring data (Page 292)
Grinding
Operating Manual, 05/2017, A5E40869190
1. Select the "Parameter" operating area.
2. Press the "Tool list", "Tool wear" or "Magazine" softkey.
3. Press the ">>" and "Search" softkeys.
4. Press the "Tool" softkey if you wish to search for a specific tool.
- OR -
Press the "Magazine location" softkey if you wish to search for a specific
magazine location or a specific magazine.
- OR -
Press the "Empty location" softkey if you wish to search for a specific
empty location.
5. Press the "OK" softkey.
The search is started.
6. Press the "Search" softkey again if the tool that was found is not the tool
that was being searched for.
The search term is kept and with "OK" you start the search for the next
tool that corresponds to the entry.
7. Press the "Cancel" softkey to cancel the search.
Manage tools
13.12 Tool details
289