Panning A Graphical Representation; Rotating The Graphical Representation - Siemens SINUMERIK 840D sl Operating Manual

Note
Selected section
The selected sections and size changes are kept as long as the program is selected.
7.8.2

Panning a graphical representation

Precondition
The simulation or the simultaneous recording is started.
Procedure
7.8.3

Rotating the graphical representation

In the 3D view you can rotate the position of the workpiece to view it from all sides.
Requirement
The simulation or simultaneous recording has been started and the 3D view is selected.
Procedure
Grinding
Operating Manual, 05/2017, A5E40869190
1. Press a cursor key if you wish to move the graphic up, down, left, or right.
1. Press the "Details" softkey.
2. Press the "Rotate view" softkey.
7.8 Editing and adapting a simulation graphic
Simulating machining
189