Siemens SINUMERIK 840D sl Commissioning Manual page 576

Configuring cycles
22.10 Turning with ShopTurn
MD52212 $MCS_FUNCTION_MASK_TECH
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 11
MD52214 $MCS_FUNCTION_MASK_MILL
Bit 3
Bit 4
MD52218 $MCS_FUNCTION_MASK_TURN
Bit 2
Bit 5
Bit 6
MD52229 $MCS_ENABLE_QUICK_M_CODES
= 0
Bit 0
Bit 1
Bit 2
Bit 3
570
Approach logic for stepped drill
Block search cycle for ShopMill / ShopTurn
= 0 The E__ASUP or F_S_ASUP cycles are not called in the block search cycle
PROG_EVENT.SPF
= 1 The E__ASUP (under ShopMill) or F_S_ASUP (under ShopTurn) cycles are not called
in the block search cycle PROG_EVENT.SPF
Approach logic using the cycle
The cycle for SERUPRO (CYCLE207) is called in the block search cycle
PROG_EVENT.SPF.
Work offset value WO cannot be entered
Identification of the end of tool lives in the program (ShopMill / ShopTurn)
Manual machine (ShopMill/ShopTurn)
Selection/deselection of the work offset using softkey
Deactivate position check for drilling and milling tools
"Inner/rear" machining is enabled in the ShopTurn screens which themselves define the
machining plane.
If you have implemented the "Clamp/release spindle" function using the manufacturer
cycle CUST_TECHCYC.SPF, then using this machine data, you can activate the
"Clamp/release spindle" parameter in the drilling and milling screens.
= 0 The "Clamp/release spindle" parameter is not displayed in the drilling and milling
screens.
ShopTurn automatically clamps the spindle if it makes sense for the particular
machining operation.
= 1 The "Clamp/release spindle" parameter is displayed in the drilling and milling screens.
You decide for which machining operation the spindle should be clamped.
Enable tailstock
Enable spindle control of the tool spindle via user interface
Enable Balance Cutting for two-channel stock removal
Coolant OFF
Coolant 1 ON
Coolant 2 ON
Coolants 1 and 2 ON
Cross-technology function mask
Milling function screen
Turning function screen
Enable quick M commands
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)