Turning - Siemens SINUMERIK 840D sl Commissioning Manual

MD24870 $MC_TRACYL_BASE_TOOL[ ]
[0] = 0
[1] = 0
[2] = 0
Note
Data records for transformations
For both data records, you can use any transformations from all available transformations
(MD24100 $MC_TRAFO_TYPE_1, MD24200 $MC_TRAFO_TYPE_2, etc.). The two data
records need not be directly next to each other.
However, the 1st data record must always be used for "Cylinder surface transformation
without groove side offset" (= 512) and the 2nd data record for "Cylinder surface
transformation with groove side offset" (=513).
22.5

Turning

22.5.1 Setting up cycles for turning
Setting the coordinate system
MD52000 $MCS_DISP_COORDINATE_SYSTEM
= 0
Examples:
0: Vertical lathe (carousel-type lathe)
19: Horizontal lathe, machining in front of the turning center
34: Horizontal lathe, machining behind the turning center (inclined bed lathe)
A detailed description of the MD52000 is provided in Section: "Activating
turning/milling/drilling technologies (Page 451)".
Turning function screen
Enable various functions under the Turning function mask in the following channel-specific
configuration machine data.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Vector of basis tool for the 2nd TRACYL transformation in XYZ
Default setting
Configuring cycles
22.5 Turning
Position of the coordinate system
469