End Of Program; Block Search - Siemens SINUMERIK 828D Function Manual

Detailed description
2.13 Control behavior in specific operating states
2.13.5

End of program

State after end of program:
From:
Synchronized action
Traversing motion
Speed-controlled
spindle
Master value
coupling
Measuring
1) End of program is delayed until the axis is at standstill.
M30
2.13.6

Block search

Non-modal and modal synchronized actions (ID)
Synchronized actions are collected during the block search but not activated. I.e. the
conditions are not evaluated, the actions are not executed.
The synchronized actions only become active with NC start. I.e. the conditions are evaluated
and the actions executed if necessary.
Static synchronized actions (IDS)
Static synchronized actions that are already active remain effective during the block search.
132
Modal and non-modal synchronized action (ID)
Aborted or inactive
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET = <value>
TRUE ⇒ The spindle remains active
FALSE ⇒ The spindle is stopped
MD20110 $MC_RESET_MODE_MASK, bit 13 = <value>
1 ⇒ The coupling remains active
0 ⇒ The coupling is released
Aborted 1
)
Aborted
Static synchronized action (IDS)
Active
Active
Active
Active
Active
Function Manual, 07/2012, 6FC5397-5BP40-3BA0
Synchronized actions