Control Behavior In Specific Operating States; Power On; Nc Reset - Siemens SINUMERIK 828D Function Manual

Detailed description

2.13 Control behavior in specific operating states

2.13 Control behavior in specific operating states
2.13.1

Power On

No synchronized actions are active during ramp-up of the NC (Power On).
Synchronized actions that are to be active immediately after the ramp-up of the NC (Power
On), must be event-driven as static synchronized actions within an ASUB or activated via the
PLC user program.
References
Detailed information on the activation of synchronized actions after ramp-up of the NC
(Power On) can be found in:
PLC user program
Function Manual, Basic Functions; PLC Basic Program for SINUMERIK 840D sl
Section "Structure and functions of the basic program" > "Functions of the basic program
with call from the user program"
Event-driven
Function Manual, Basic Functions; Mode Group, Channel, Program Operation (K1)
Section "Program operation" > "Event-controlled program calls"
2.13.2

NC reset

State after NC reset:
From:
Synchronized action
Traversing motion
Speed-controlled
spindle
Master value
coupling
Measuring
130
Modal and non-modal synchronized action (ID)
Aborted or inactive
MD35040 $MA_SPIND_ACTIVE_AFTER_RESET = <value>
MD20110 $MC_RESET_MODE_MASK, bit 13 = <value>
The traversing motions are aborted
TRUE ⇒ The spindle remains active
FALSE ⇒ The spindle is stopped
1 ⇒ The coupling remains active
0 ⇒ The coupling is released
Aborted
Function Manual, 07/2012, 6FC5397-5BP40-3BA0
Static synchronized action (IDS)
Active
Synchronized actions