Troubleshooting - Beko BX 109 C Installation Manual

9

Troubleshooting

To save the cost of a service call, please try the suggestions below to see if you can solve your problem
without outside help.
Causes
• The power switch is released.
• Power supply failure.
• The fuse is burnt.
• It doesn't reach the setting time for starting
up.
Causes
• It is not four minutes after switch off.
• Room temperature is lower than the setting
temperature under cooling mode or higher
than setting temperature under heating mode.
The wind blowing out, but the cooling/heating effect is bad
Causes
• Mistakes in temperature setting.
• The air filter is blocked by dust.
• The air inlet or outlet of machine is blocked.
• Turn the air conditioner on in very hot room.
• Cooling capacity is insufficient.
• The doors or windows are open.
Causes
• The ground is not level or not flat enough.
38 / 88 EN
Air condition will not operate
Unit doesn't start when pressing ON/OFF button
Noise or vibration
• Switch on the power.
• Wait for the recovery of power supply.
• Replace the fuse by professional.
• Wait or eliminate the original setting.
• Wait four minutes.
• Reset the setting temperature.
• Set a proper temperature, setting temperature
should be lower than ambient temperature.
• Clean the air filter.
• Remove the obstruction.
• Allow additional time to remove stored heat
from walls ,ceiling, floor and furniture.
• Reconfirm the required cooling/heating.
capacity with your dealer.
• Close the doors and windows.
• Place the unit on a flat, level ground if possible.
Mobile room air conditioner / Installation Manual
Solutions
Solutions
Solutions
Solutions