Siemens M20 Terminal Technical Description page 134

Siemens Information and Communication Products
AT^SSET Set some unsolicited result codes
Test command Response
AT^SSET=?
OK
Read command Response
AT^SSET?
^SSET: <SIM ready>
Parameter
<SIM ready>
Set command Response
AT^SSET = [<SIM
Set the presentation of unsolicited result code.
ready>],[<bbnc>]
Parameter
<SIM ready>
<bbnc>
Note:
The current value of the parameters can be stored using the command
to user defined profile
The factory default value (0) is set with command
defaults
Reference Unsolicited result code
Unsolicited result code sent after finish reading of SMS and phone books from SIM:
^SSIM READY
Version 8 dated 15.03.00
0 or 1 representing the setting of unsolicited result code presentation.
Presentation of unsolicited result code ^SSIM READY:
BREAK is sent before NO CARRIER on dropped data call:
. On power up or with the ATZ command the value ist read from the EEPROM.
.
0 Unsolicited result codes off
1 Unsolicited result codes on
0 BREAK not sent
1 BREAK sent
AT&F Set all current parameters to manufacturer
AT command interface
AT&W Store current parameter
A
134