Siemens M20 Terminal Technical Description page 162

Siemens Information and Communication Products
8.2.5.2 Start Procomm Plus
(START - programs - Procomm - Procomm Plus)
To activate configuration file:
Activate "M20_start" by double-clicking in the data - pulldown menu.
M20T connected and ON (see chapter 3.3.1)
This automatically configures the system to connect to the M20T via COM1.
The script "Start" automatically is activated and a sequence of commands is executed giving information about the settings
of the M20.
Enter the PIN code in the pop up window.
Once the M20T is booked into the net, -- +creg:1 - network information is displayed
M20T Ready.
NOTE: If the script is unable to process a command, there is a 15 second internal timeout after which the next command
is automatically sent to the M20.
NOTE: If the script does not operate correctly it can be stopped/exited and restarted with the Button .
The Procomm Plus scripts for Data, Voice and SMS incoming and outgoing can be activated from the script window.
Using the script control button
8.2.6 Setting parameters
8.2.6.1 Enter PIN1
at+cpin?
+CPIN: SIM PIN
OK
at^spic
^SPIC: 3
OK
at+cpin="xxxx"
OK
8.2.6.2 Enter PUK1
at+cpin?
+CPIN: SIM PUK
OK
at^spic
^SPIC: 10
OK
at+cpin="xxxxxxxx","xxxx"
OK
at+cpin?
+CPIN: READY
OK
8.2.6.3 Change PIN1
Version 8 dated 15.03.00
a script can be started and stopped.
Ask which PIN is required
SIM PIN is needed
Display PIN counter
3 attempts still available
Enter PIN
SIM PUK is required
10 attempts still available for SIM PUK
Enter PUK and new PIN
SIM is ready
Application notes
A
162