Fujitsu ETERNUS LT140 User Manual page 47

Chapter 4 Setting Backup Software
4.5 NetVault
3
4
5
6
FUJITSU Storage ETERNUS LT140 Tape Library User's Guide -Server Connection-
In the [Edit Drive] page that appears, click the [Configuration] tab and check that the [Cleaning
Tapes Supported] checkbox is selected. If cleared, select it.
Click the [OK] button to go back to the [Manage Devices] page in the tree view mode.
When the drive becomes idle, click the name of the same drive again and select [Configure].
In the [Edit Drive] page that appears, click the [Generic Cleaning] tab and set the following
Generic Cleaning items.
• Issue a load command to start cleaning cycle: off (the default setting is "on")
• Use Generic Cleaning: on (the default setting is "off")
After confirming that the checkboxes are set correctly, click the [OK] button to go back to the
[Manage Devices] page in the tree view mode.
The setting of one drive is now complete. When using multiple drives, set the other drives in the
same way.
After setting all the drives, proceed to the library setting.
Copyright 2019 FUJITSU LIMITED
47
P3AG-3752-03ENZ0