Combined Operation; Analyzer Module/Installation Location Combinations; Safety Instruction(S) - Siemens SIPROCESS GA700 Operating Instructions Manual

3.7

Combined operation

3.7.1

Analyzer module/installation location combinations

3.7.1.1

Safety instruction(s)

NOTICE
Combination of modules with hoses and pipes
Combinations of analyzer modules with hoses and analyzer modules with pipes are not
permitted:
● Only combine analyzer modules with hoses with other analyzer modules with hoses, and
● If required, you can adapt the modules with combination sets ("Combination set with
Additional information on combination sets is available from your Siemens partner:
→ Technical support (Page 144).
Note
Installation of analyzer modules
The analyzer module is only installed in the device at the factory when you select the options
"D00 to D99" when ordering an analyzer module.
If you do not specify the module assignment/installation location during the ordering process,
the analyzer module is delivered separately from the device (supplied separately).
If the analyzer module is supplied separately, you must install it yourself. You will find the
information on installation only in the Operating Instructions of the device: → References
(Page 141).
Rack-mounted device
Operating Instructions, 05/2015, A5E31874006-03
only combine those with pipes with other analyzer modules with pipes.
hoses"/"Combination set with pipes").
Description
3.7 Combined operation
39