Cables; Figure 5-1 Wiring And Cabling - Siemens SIPROCESS GA700 Operating Instructions Manual

Installing/removing modules in the rack-mounted enclosure

5.3 Cables

5.3 Cables
Safety instructions
NOTICE
Cable damage
Make sure that the cables are carefully laid and secured again after installation or when you
replace an analyzer module. Cables can otherwise be damaged by friction or other
mechanical influences. Route the cables close to the enclosure wall.
Note
Spare parts
If you install analyzer modules into the rack-mounted enclosure at a later time, you must order
the corresponding cables separately.
Note
Cable ties
Use only the high-temperature cable ties listed in the spare parts list:→ Spare parts/
accessories (Page 146).
Overview
①
②
Figure 5-1
Each analyzer module has a cable set. The CAN Bus cable (12-pin ribbon cable) which
interconnects all components always has the full range of connections.
68
Ribbon cable
Power cable
Wiring and cabling
Rack-mounted device
Operating Instructions, 05/2015, A5E31874006-03