Cis Type Setting; Installing Firmware - Brother ADS-1000W Service Manual

2.2

CIS Type Setting

(1) Press and hold the
state. LEDs except WiFi LED light.
(2) Press the [to USB], [to Network Device2], and [to Network Device1] keys in this order. The
to USB, Error,
(3) Connect the computer to the machine with the USB cable.
(4) Turn ON the computer.
(5) Open the temporary folder and double-click "Filedg32.exe" to start it, and select the
"Brother Maintenance USB Printer".
(6) Drag and drop the "CDSM59-1-3-1_FS.pjl" file in the temporary folder onto the "Brother
maintenance USB Printer" icon. CIS type setting is completed. If the firmware is not the D
version or later, after drag and drop, the CIS type is not be completed with a beep.
2.3

Installing Firmware

Note:
• Even if the latest firmware is installed as described in "2.1", install the firmware again.
The parameters of the CIS type are set by installing the firmware after the CIS type
setting.
(1) Create a folder in the top hierarchy of USB flash memory drive and name it "Brother".
(2) Save main firmware (LZ****.pjl) to the "Brother" folder created in USB flash memory drive.
Note:
• Before saving the firmware to the USB flash memory drive, check if the file name
with extension ".pjl" is for the model to be installed with the firmware. If "Brother"
folder has multiple firmware files, it fails to specify the execution file, resulting in
install failure due to invalid operation.
(3) Press and hold the
state. LEDs except WiFi LED light.
(4) Press the [to USB], [to Network Device2], and [to Network Device1] keys in this order. The
to USB, Error,
(5) Connect the USB flash memory drive with firmware data to the machine.
(6) Press the [to Network Device1] key, and then [to Network Device2] key twice. The to PC
and to USB LEDs light.
(7) Press the
installation.
(8) When the firmware is successfully installed,
the ready state.
key for five seconds or longer when the machine is in the ready
, and LEDs light and the machine enters the maintenance mode.
key for five seconds or longer when the machine is in the ready
, and LEDs light and the machine enters the maintenance mode.
key. All LEDs start flashing in turns, and the machine starts firmware
LED flashes and the machine returns to
4-9
Confidential