Brother ADS-1000W Service Manual page 111

APPENDIX 2 DELETING USER SETTING
Initializes setting values registered in EEPROM including operation parameter and user switch.
<Operation Procedure>
(1) Press and hold the
state. LEDs except WiFi LED light.
(2) Press the [to USB], [to Network Device2], and [to Network Device1] keys in this order. The
to USB, Error,
(3) Press the [to Network Device2] key. All LEDs go out.
(4) Press the [to Network Device2] key three times. The to Network Device1 and to Network
Device2 LEDs light.
(5) Press the
(6) Press the
maintenance mode.
(7) Press the [to Network Device2] key. All LEDs go out.
(8) Press the [to Network Device1] key, and then [to Network Device2] key three times.
The to PC, to USB, and to Network Device2 LEDs light.
(9) Press the
INFORMATION
key for five seconds or longer when the machine is in the ready
, and LEDs light and the machine enters the maintenance mode.
key. Only the LED lights.
key again. The machine initializes EEPROM and returns to the initial state of
key. The machine returns to the ready state.
App. 2-1 Confidential