Second Side Cis Flat Cable - Brother ADS-1000W Service Manual

8.14 Second side CIS flat cable

(1) Turn over the upper document chute.
(2) Remove the second side CIS flat cable from the upper document chute.
Second side CIS
flat cable
HARNESS ROUTING: Refer to
Assembling Note:
• Attach the second side CIS flat cable to the upper document chute by engaging the
marking on the second side CIS flat cable with the edge of the rib on the upper
document chute as shown in the figure above.
• Fold the second side CIS flat cable as shown in the illustration below.
Reinforcing plate (CIS side)
45°
17 mm
7.5 mm
Edge of the rib
Marking
Fig.3-22
"9. Upper chute
45°
Fig.3-23
3-27
Second side CIS flat cable
Upper document chute
ASSY".
Mountain fold
Valley fold
139 mm
Taped area
83 mm
25 mm
45°
Electrode
(main PCB side)
Confidential