Specifications Of The Dn611; Function Specifications - Toshiba 2000 V Series Manual

1.5 Specifications of the DN611

1.5.1

Function specifications

Table 1-4 lists the function specifications of the DN611. The general specifications of the
DN611 conform with the S controller.
Module model
Media access method
Modulation
Transmission line
Data rate
Maximum network
length
Maximum number of
nodes
Connector
Connecting cable
Communication function
RAS function
Current consumption [mA]
Dimensions [mm]
Weight [g]
Board specification
Mounting
Number of modules
Access
Note: CSMA/NBA : Carrier Sense Multiple Access with Non-destructive Bitwise Arbitra-
tion
6F8C0845
Table 1-4 Function Specifications
Item
125 kbps
500 m
64 per network (1 master device, 63 slave devices)
MSTBP 2.5/5-STF-5.08 AB GY AU SO
TMSTBP 2.5/5-STF-5.08 AB GY AU
made by Phoenix Contact Corporation
DeviceNet THICK cable (thick cable)
DeviceNet THIN cable (thin cable)
1. Polling instruction/response (synchronous/asynchronous)
2. Bit strobe instruction/response (synchronous/asynchronous)
1. Self-check at power ON
ROM, RAM, CAN controller,
S controller interface buffer memory
2. RAS information in S controller buffer memory
3. Information by reading RAS information
Event trace
CAN controller (circuit) information
4. Time setting function
5. Module status, network status indicated by the 7-segment LED
on the front panel
S controller (5 VDC): 500 mA
Network (24 VDC): 90 mA
32.5 (W) × 138 (H) × 102.1 (D)
200
One slot (slot width)
Parallel I/O bus (G2 bus) of the Integrated Controller V Series
model 2000
See 1.5.2 Number of mounting modules.
READ/WRITE instructions (module control, data input/output)
1.5 Specifications of the DN611
Specifications
DN611
Compatible with DeviceNet
CSMA/NBA method (Note)
Baseband
Bus
250 kbps
250 m
1
500 kbps
100 m
13