Mounting In The Base Unit - Toshiba 2000 V Series Manual

3.3 Mounting in the Base Unit

Mount your DN611 in the G2 I/O slot of the base unit for the S controller and lock it. For
details, see the description of module installation in the Sequence Controller S2 User's
Manual.
1. Since the DN611 is designed for the model 2000 of the Integrated Controller V Series, be
sure to mount your DN611 in the base unit, instead of using it alone. Don't use it for other
applications. Otherwise, a there is the danger of electric shock, bodily injuries, and/or
mechanical malfunction.
1. Be sure to turn power off (switch off the S controller and the network) before mounting or
removing the DN611. Failing to do so will cause electric shock, malfunction, and/or failure.
2. Keep the DN611 free of wire fragments and other foreign matter. Failing to do so can cause
fire, failure, and/or malfunction.
3. Secure the joints of the connectors and cables and the N611 mounted in the base unit with
stoppers or screws to prevent them from slipping out of place or getting unsteady.
If they are not adequately secured, vibration, etc. can cause trouble or malfunction.
The number of DN611s that can be mounted in one S controller system is as specified in
1.5.2 Number of mounting modules.
The DN611, a low-voltage I/O unit, must be installed in the left part of the base unit, and
high-voltage I/O units in the right part of it. Separate the cables for low-voltage units from
those for high-voltage units. (See 8.4 Network Installation for network cabling.)
The current consumption of the S controller power module for the DN611 (5 VDC) is 0.5
A. To determine the power capacity, refer to 1.5.2 Number of mounting modules and to
the section on power capacity in the Sequence Controller S2 User's Manual.
6F8C0845
3.3 Mounting in the Base Unit
Caution
Caution
3
29