Ball-Picker Mount; Bottom Bracket - Toro 07161 Installation Instructions Manual

11
Installing the Ball-Picker
Mount
Parts needed for this procedure:
1

Ball-picker mount

1

Bottom bracket

14 Flange bolt (3/8 x 1 inch)
14 Flange locknut (3/8 inch)
Drilling the Center-Channel Plate
1. Assemble the ball-picker mount onto the bumper
support as shown in
Figure 48
1. Ball-picker mount
Figure 48.
2. Bumper support
2. Loosely assemble the bottom bracket onto the
ball-picker mount
(3/8 x 1 inch) and 4 flange locknuts (3/8 inch).
1. Bottom bracket
2. Flange locknut (3/8 inch)
3. Align the rear-most edge of the bottom bracket
with the edge of the access opening in the
center-channel plate
1. Hole (Bottom bracket)
4. Mark the 4 hole locations of the bottom bracket
onto the center-channel plate as shown in
g237670
50.
5. Remove the 4 flange bolts (3/8 x 1 inch), 4
flange locknuts (3/8 inch), and bottom bracket
from the ball-picker mount
23
(Figure 49) with 4 flange bolts
Figure 49
3. Ball-picker mount
4. Flange bolt (3/8 x 1 inch)
(Figure 50).
Figure 50
2. Center-channel plate
(Figure 49).
g237671
g237673
Figure