Table of Contents
Advertisement
Figure 59
1. Flange bolt (3/8 x 1 inch)
2. Ball-picker mount
2.
Torque the bolts and nuts to 37 to 45 N∙m (27
to 33 ft-lb).
12
Installing the Bumper and
Hood
No Parts Required
Trimming the Bumper
1.
On the back side of the bumper, mark 1
inch above the bottom of the bumper in the
depressed center area as shown in
g237837
3. Flange locknut (3/8 inch)
4. Top of the machine
Figure
60.
1. Area to trim
2.
Cut out the area marked to create clearance for
the ball-picker mount.
Assembling the Bumper to the
Machine
1.
Support the bumper so that it aligns with the
bumper and headlight mount as shown in
42.
2.
Install the bumper with the 8 flange-head bolts
removed in
9 Removing the Hood and Bumper
(page
20).
Assembling the Hood to the
Machine
1.
With the front of the hood rotated forward, align
a clevis pin at the front of the hood with the
corresponding spring latch as shown in
41
of
9 Removing the Hood and Bumper (page
20).
2.
Slide the clevis pin into the notch so that it is
secured by the pivot latch.
3.
Repeat step
2
4.
Lower the hood and secure it with the rubber
latches at each side of the hood as shown in
Figure
40.
26
Figure 60
2. 1 inch from the bottom
at the other side of the hood.
g237868
Figure
Figure
Advertisement
Table of Contents
