Toro 07161 Installation Instructions Manual page 28

14
Assembling the Latch Pin
Parts needed for this procedure:
2 Latch pin
4 Thrust washer
2 Pin guard
2 Jam nut
Procedure
1. Align the latch pin and the pin guard with the
opening at the mount bracket as shown in
63.
2. Insert the latch pin (without the washers at first)
into the pin guard
Note:
If the latch pin is not centered in the door
latch, add 1 or 2 of the thrust washers. Use the
thrust washers to align the latch pin to the door
handle latch.
Figure 63
1. Jam nut
2. Mount bracket
3. Thrust washer
3. Align the latch pin and the jam nut onto the back
side of the opening at the mount bracket
63).
4. Tighten the jam nut onto the latch pin by hand
(Figure 63).
(Figure 63).
4. Latch pin
5. Pin guard
15
Installing the Canopy
Parts needed for this procedure:
1 Sunshade
2 Clip
4 Sealing washer
4
Hex-flange bolt (1/4 x 1 inch)
2 Friction washer
4 Plastic washer
2 Flange bushing
Figure
Procedure
1. Install the sunshade to the front plates using 2
clips, 2 sealing washers, and 2 hex-flange bolts
(1/4 x 1 inch) as shown in
Important:
to the hex-flange bolts before installing.
g213550
1. Hex-flange bolt (1/4 x 1
inch)
2. Sealing washer
3. Sunshade
(Figure
2. Install the sunshade to the rear crosslink using
2 hex-flange bolts (1/4 x 1 inch), 2 sealing
washers, 2 friction washers, 4 plastic washers,
and 2 flange bushings
28
Figure 64.
Apply thread-locking compound
Figure 64
4. Clip
5. Front plate
(Figure 65).
g035017