• If the message above does not appear, check the installation procedure
and configuration settings, making sure there are no select code conflicts
and that the card is firmly seated in an even-numbered slot. If the
message still does not appear, call your HP Service Representative for
assistance.
Filling Out the Worksheets
The following "Worksheet Entry" contains information needed to use the LAN
Interface with HP- UX.
Copy this information to a worksheet or simply remember to refer here when
you need it. If you changed the select code, write in your new select code instead
of
21.
When finished, you'll be ready to install your next peripheral or interface.
HP-UX System Worksheet Entry.
Table 10-18.
Interface N arne
Select Code
HP 98643A
21
Note this information regarding HP-UX operating systems:
• The character-mode major number for an IEEE-802 network is 18. The
character-mode major number for an Ethernet
™
is 19. (Ethernet
™
is a
trademark of the Xerox Corporation.)
• A typical
mknod
for a LAN Interface at select code 21 on an IEEE-802
(major number 18) Local Area Network is:
# mknod /dev/lan 18 c Ox150000
The
15
in the minor number represents the select code (15 is the
hexadecimal value for 21).
Configuring Popular Accessory Cards
10-33
10