Setting The Modem Enable Switch - HP 9000 300 Series Hardware Configuration Manual

1. Find the group of switches labeled SW1 by referring to Figure 10-10.
Switches 4 and 5 in this group determine the interrupt level.
2. Set the interrupt level to the desired value by referring to Table 10-19:
Table 10-19.
Interrupt Switch Switch
Level
5
4
3 0 0
4
0
1
5
1
0
6 1 1
Setting the MODEM ENable Switch.
1. Find the group of switches labeled SW1 by referring to Figure 10-10. Switch
3 in this group is the MODEM EN able switch.
2. Set the MODEM EN able switch as follows:
• If you intend to connect an HP 2601A printer, an HP 2686A Laserjet
printer, an HP
92205Aj
C Hayes Smartmodem, or a controller, set this
switch to 1 as shown in Figure 10-10 .
• If you intend to connect a terminal or the HP 39800j01A bar code reader,
set this switch to 0, which is
opposite
that shown in Figure 10-10.
Setting the 626 Switch.
1. Find the group of switches labeled SW1 by referring to Figure 10-10. Switch
2 in this group is the 626 switch.
2. Set the 626 switch to 1 as shown in Figure 10-10.
Set the REMOTE Switch.
1. Find the group of switches labeled SWI by referring to Figure 10-10. Switch
1 in this group is the Remote switch.
2. Set the Remote switch as follows:
Configuring Popular Accessory Cards 10-37
10