Configuration Task Procedures - HP 9000 300 Series Hardware Configuration Manual

1
Table 1·1. Configuration Task Procedures
To Change This Configuration, Refer to chapter and
do these tasks:
Internal interface values, 1. Chapter 2; Learn how to use Configure
Mode.
2. Chapter 3; Change the internal interface
configuration.
Boot mode or system select,
1. Chapter 2; Learn how to use Configure
Mode.
2. Chapter 3; Change the boot mode.
LAN type, 1. Chapter 4; Access your controller's internal
assemblies.
2. Chapter 8; Change the LAN type.
Add more memory, 1. Chapter 2; Determine existing memory.
2. Chapter 4; Access your controller's internal
assemblies.
3. Chapter 5; Add more memory.
Mass storage device 1. Chapter 4; Access your controller's internal
configuration,
assemblies.
2. Chapter 6; Change the device configuration.
Graphics mode, 1. Chapter 4; Access your controller's internal
assemblies.
2. Chapter 7; Change the graphics mode.
LAN type, 1. Chapter 4; Access your controller's internal
assemblies.
2. Chapter 8; Change the LAN type.
Bus expander,
1. Chapter 4; Access your controller's internal
assemblies.
2. Chapter 9; Change the bus expander.
Accessory cards
1. Chapter 10; Determine supported cards.
2. Chapter 10; Change the card's configuration.
Using This Manual 1 .. 3